Clumsy. Manual. No multimedia support really. Compiling everything on 486 machines took hours.

Can’t say I look back fondly on it.

BeOS community was fucking awesome though. That felt like the cutting edge at the time.

So what’s the question?

Is there a question in here somewhere?

I believe Dragora is a Chinese-specific distro. Probably not going to find a lot of help for that here.

1. Check if you have Snaps enabled, and if they are taking up space
2. du -hsc /* to get a fairly quick look at what directories holding the most data, then go deeper into each directory to figure out where everything is.
3. Don’t use Snaps if that is the cause.

You probably just formatted with an incompatible filesystem. It would be helpful to know which option you chose, but just make sure it’s ex-FAT, and not FAT16/32.

Need specs. Have you checked your free memory while games are running?

And what happens when you enable each of these rules one at a time, querying between each application of a rule? It’s only 5 rules.

It’s blocking the querying as well? It’s hard to discern where the issue is.

Mdns is udp on port 5353, and your rules don’t seem to block outgoing udp, so your dig should work if enabled or not.

Same as any other distro. Best practices.

…until people who don’t know better start googlin’

It’s a gateway to SNAP, which is why it’s bad.

The dumbest possible choice, IMTO

Dude straight up says “SteamOS doesn’t work on everything” and in almost the same sentence says “Bazzite is cool”. This guy does not understand puters AT ALL 🤣

Also, the rant about the terminal while complaining about Arch about made me laugh so hard I’d sploosh.

Using a tool for a job you don’t understand will yield unexpected results, fool. 😘

Those aren’t fonts, those are icon sets.

This model appears to be 15 years old. The battery is just dead and won’t hold a charge at this point I’d imagine. No replacement out there is going to be worth the risk in buying. At least it still works when plugged in I guess?

Oh, nvm. You said Pi5, which isn’t officially supported. See if this works though: https://rpmfusion.org/Howto/RaspberryPi#Raspberry_Pi_5

Did you update the EEPROM first?

TP-Link is not secure

Look at the Framework Refurb store.

The other option here seems to be using uboot to boot your SD card: https://docs.u-boot.org/en/latest/usage/partitions.html

Since you know you can boot it via USB, you can just tell it to then boot from your SD Card instead of relying on the r4s to boot it. Docs say it’s possible to flash to the eMMC as well https://wiki.friendlyelec.com/wiki/index.php/NanoPi_R4S#eMMC_Boot